Why is my Horizon Fitness treadmill not working?
Troubleshoot non-functioning console keys by unplugging the treadmill and firmly massaging all console keys with a circular motion. Plug the treadmill back in and check the keys. If they still don’t work, unplug the treadmill and wait 60 seconds for all energy to discharge.
Why does my treadmill belt not move?
If the belt is too tight, it could cause enough tension that the motor can’t turn the belt. This is most likely the cause of your belt not moving if you recently adjusted the belt tension due to slippage. If you can’t raise it at least 2 to 3 inches off the walking deck, the belt is too tight.
What does E1 mean on Horizon treadmill?
An E1 code just means that the console is not getting a reading from the reed switch (Speed Sensor). If the running belt moves for several minutes and then produces the E1 error, this is most commonly a result of the running belt needing lubrication.
How do I reset my Horizon Fitness treadmill?
Press and hold the “Stop/Pause” button for at least 3 seconds to reset the treadmill. You will hear a beeping noise, which indicates the treadmill has been reset. Release the “Stop/Pause” button.
How do you fix a treadmill that won’t turn on?
If the electrical outlet works, unplug the treadmill and check the power cord for damage. Replace the power cord if it’s damaged. If the power cord is okay, check the circuit breaker switch on the treadmill and reset the circuit breaker switch if it’s tripped.
How do I reset my horizon treadmill?
Why is my treadmill not working?
A failed power supply, broken power cord, tripped circuit breaker switch, failed circuit breaker switch, bad power switch, wiring failure, bad motor control board or failed console display can prevent the treadmill from powering up. If the outlet is dead, reset the house circuit breaker to restore power to the outlet.
How do I fix E1 error?
Clean the Air Filter: If the E1 error code appeared as a reminder to clean the air filter, turn off the unit, and then open the front panel and remove the filter. Clean it with soap and water and let it dry before replacing it. If you can’t remove all the dirt and grease it has collected, it’s time to replace it.
How do I fix E4 error on treadmill?
Error code “E4” may appear in the SPEED display if the walking belt is moving at a slow speed, and there is excessive stress on the motor. Remove the key, wait for ten seconds, and then reinsert it. If you weigh over 200 pounds, it may be helpful to increase the incline of the treadmill.