What can I use to clean my Paslode nail gun?
- Let the tool cool down beforehand, and remove the battery and gas fuel cell.
- ONLY use official Paslode lubricating oil.
- Use official Paslode degreaser cleaner.
- Use a clean, lint-free cloth.
- Make sure you properly tighten all screws when reassembling the tool.
Can you use brake cleaner on Paslode?
The brake part cleaner you use on your truck also works nearly as well as the Paslode cleaner and is the best Paslode degreaser cleaner alternative. Keep in mind that it’s best to use non-chlorinated brake cleaner such as this.
Can you use WD40 to clean paslode?
wd40 just clogs everything up. the paslode cleaner is just the same as brake part cleaner that you would use on your car. you can get it cheaper than paslode cleaner at your local motor factors. spray it all over to remove old oil and dust ,leave for 5 mins and re-oil.
Can you use WD40 in a Paslode gun?
Never use WD40, motor oil, transmission fluid or aerosol lubricants. Many generic lubricants eat through rubber over time, which will cause more harm than help in the long run (remember most pneumatic nail guns have rubber o-rings).
Why is my Paslode nail gun misfiring?
Misfiring is the most common repair that we conduct. Possible causes for a Paslode nail gun not firing are: A nail jam is stopping the nails from moving forward. The gas fuel cell is empty, out-of-date or not attached properly.
What kind of cleaner to use on Paslode nail gun?
Paslode recommend that you use their official cleaner as, again, it’s specially formulated for their machines. Other cleaners may chemically damage the nailer’s electrical, plastic and rubber parts. They may also leave a residue which can cause damage to both you and the tool.
How often should I Clean my Paslode Nailer?
Paslode recommend that you clean and lubricate your nailer every 50,000 shots. If it’s being used in a dirty environment or at high nailing rates for extended periods of time then this should be more often.
What are the parts of an im250s Nailer?
TOOL SCHEMATIC AND PARTS www.paslode.com Part No. 916000 Model IM250S Li STRAIGHT 16Ga. FINISH NAILER PARTS LEGEND 1 904555 1 Grille * 2 900648 1 Filter 3 901064 4 Shoulder Screw 8-32 x 1-3/8” 4 902446 1 Cap 5 904557 2 Scre w, SHC (yellow) 6 901119 1 Retaining Ring 8