How do I configure my Dlink router?

Setting up a D-Link Router

1. Open the router in a new browser tab. Open your browser and navigate to http://192.168.0.1, the default IP address of the D-Link router.
2. Enter the D-Link router password.
3. Setup a strong password.
4. Select your Timezone.
5. Configure your internet connection.

How do I access D-Link settings?

Step 1: Open your web browser and enter the IP address of the router into the address bar (not in google). The default IP is 192.168. 0.1, or using the link: http://dlinkrouter.local. Step 2: You should be taken to a D-Link login page.

How do I configure my Dlink router as an access point?

How to change a D-Link router to AP mode

1. Connect a computer to the D-link router and launch a web browser.
2. Visit the following router configuration page: http://192.168.0.1.
3. You are prompted to enter a username and password.
4. Click Setup > Local Network.
5. Set the DHCP Mode to Off.
6. Click Apply Changes.

How do I reset my Dlink DIR 600 router?

To reset the DIR-600 router:

1. Power on the router and flip it around so you have access to the back where the cables are connected.
2. With a paperclip or another small and pointed object, press and hold the Reset button for 10 seconds.
3. Wait about 30 seconds for the router to reboot.

How do I change my Dlink DIR 600m WIFI password?

How do I change the login password to my DIR router?

1. Step 1: Open a web browser and enter the IP address of the router in the address bar (default is 192.168.
2. Step 2: The default username is admin and the password is blank (nothing).
3. Step 3: Click the Tools tab and then click Admin to the left.

What does the D-Link Dir 600m WiFi router do?

A password will be e-mailed to you. The D-Link DIR 600M is an affordable home router helps you to share your Internet connection with other WiFi-enabled devices including Smartphones, Laptops, Tablets etc. This is an entry-level router capable of sharing speeds up to 150mbps.

Is the D Link logo a registered trademark?

D-Link and the D-Link logo are trademarks or registered trademarks of D-Link Corporation or its subsidiaries in the United States or other countries All other compan or product names mentioned herein are trademarks or registered trademarks of their respective companies. Copright © 00 b D-Link ystems Inc.

How do you mount a dir-600 to a wall?

You can mount the DIR-600 to a wall or a partition for easy and convenient placement of your device. To wall mount your device, A. Screw the provided screws with the equipment to the wall or partition where the device to be placed. B. Place the mounting holes on the bottom of the device over the screws to mount it to the wall or partition.

Can a dir-600 pass through a VPN?

• Secure Multiple/Concurrent Sessions – The DIR-600 can pass through VPN sessions. It supports multiple and concurrent IPSec and PPTP sessions, so users behind the DIR-600 can securely access corporate networks.