If you don’t like to read, you haven’t found the right book

What is Rsrp Rsrq Sinr and RSSI?

RSSI = Received Signal Strength Indicator. RSRP = Reference Signal Received Power. RSRQ = Reference Signal Received Quality. SINR = Signal to Interference plus Noise Ratio. RS SINR or RSSNR = Signal to Noise Ratio.

What is RSSI LTE?

April 25, 2017 July 21, 2020 Author LTE. RSSI represents the total received wide-band power measured over entire bandwidth by UE. RSSI is not reported to eNodeB. It is computed to be used for the calculation of RSRQ in LTE system.

What is Rsrq 4G?

The LTE specification defines a second value, RSRQ (Reference Signal Received Quality), as the ratio of the carrier power to the interference power: essentially this is a signal-noise ratio measured using a standard signal.

How can I improve my RSRQ in LTE?

How Can I Improve My 4G LTE or 5G Speed?

  1. Get a New Phone/Hotspot. If you’re using an old device, a new phone or hotspot may allow you to connect to new bands.
  2. Use External Antennas. Many hotspots from major carriers like AT, Verizon, Sprint and T-Mobile support external antenna ports.
  3. Use a Signal Booster.

What can cause poor RSRQ?

Poor RSRQ reasons:

  • Bad RSRP.
  • Overshooting from neighbor cell.
  • Less intersector seperation of the same site.(65deg is good) 4.High utilization of the cell( If the utilization increases the RSSI increases which degrade the RSRQ).


RSRP – Reference Signal Received Power: RSRP is a RSSI type of measurement, as follows there are some definition of it and some details as well. RSRQ – Reference Signal Received Quality: Quality considering also RSSI and the number of used Resource Blocks (N) RSRQ = (N * RSRP) / RSSI measured over the same bandwidth.

What is RSSI RSRP Rsrq?

What is RSSI Rsrp Rsrq?

What is Rsrq DB?

RSRQ – Indicates quality of the received signal, and its range is typically -19.5dB(bad) to -3dB (good).

What is RSSI and its acceptable signal strength?

Signal (a.k.a. RSSI) is the usable strength of the radio waves, expressed in decibels between 0dBm (strongest) and -120dBm (weakest). Smaller negative numbers represent a cleaner/stronger signal. For wireless data communications, normal range is -45dBm to -87dBm. Anything below -85dBm is generally unusable, and over -50dBm can be considered perfect.

What is a good RSRP?

RSRP – The average power received from a single Reference signal, and Its typical range is around -44dbm (good) to -140dbm (bad). RSRQ – Indicates quality of the received signal, and its range is typically -19.5dB (bad) to -3dB (good).

What is RSRP signal?

RSRP (Reference Signal Receive Power) is the average power of Resource Elements (RE) that carry cell specific Reference Signals (RS) over the entire bandwidth, so RSRP is only measured in the symbols carrying RS. While RSSI (Received Signal Strength Indicator) is a parameter which provides information about total received…