If you don’t like to read, you haven’t found the right book

What are the measurements to make a pillowcase?

Start by cutting two identical size pieces of fabric, that are each 29.5 inches long and 21 inches wide. This will create a 20×26 inch pillowcase when finished. *If you wanted a Queen size pillowcase instead, you would cut two pieces of fabric that are 33.5 inches long and 21 inches wide.

How much do you overlap envelope pillows?

Basic Instructions: The ends will overlap approximately 3″ at the back when finished. This extra fabric is to ensure that the pillow form will be hidden when the pillow cover is in place. To calculate the fabric measurement you will need measure your pillow insert.

How do you make an 18 inch envelope pillow cover?

To make an envelope pillow cover for an 18×18 pillow form:

  1. Wash and dry your fabric (if it’s a natural fibre fabric) so it doesn’t shrink later on.
  2. You’ll need to cut two pieces of fabric, cut piece A 18×18 inches.
  3. Cut piece B 18×26 inches.
  4. Then cut piece B in half.
  5. Hem one side of each B piece (the longest side).

How to sew a pillowcase from a pattern?

Directions. 1 Cut Fabric. If laying pattern pieces onto flat fabric, use the layout on the left, below. “Fold Line” written on the pattern piece refers to the fold 2 Stitch Pillowcase Side & End. 3 Create Hem. 4 Stitch Hem. 5 Benefit Of Sewing – Good Quality!

How big do you cut out a pillowcase?

Please enjoy and don’t forget to Like and SUBSCRIBE over on YouTube to be kept up to date with new videos as they come out. For the standard size pillowcase, start by cutting out a rectangular piece 27″ x 43″ big, from the main fabric. Cut out the cuff fabric into a piece that’s measuring 11 x 43 inches.

How to make a pillow case from a burrito?

How To Sew a Pillowcase. 1 STEP 1: Cut out fabric according to these pillowcase measurements. For the standard size pillowcase, start by cutting out a rectangular piece 27″ x 2 STEP 2: Prepare the cuff and trim. 3 STEP 3: Layer all fabrics. 4 STEP 4: Roll it up (burrito method) 5 STEP 5: Start sewing the burrito style pillow case.

How do you make a pillowcase out of cuff?

Place the body fabric on top of the cuff, right side down, matching its raw edge with the other aligned edges (photo shows the body fabric rolled up, with cuff fabric beneath it). Pin the matched raw edges together and sew along the entire width (about 41 to 42 inches) with a 1/4-inch seam allowance.