How do I do the throttle body relearn procedure?
Turn the ignition switch on and wait 3 seconds. Immediately after the 3 seconds, the accelerator pedal must be pressed and released 5 times within 5 seconds. Wait 7 seconds and fully press the accelerator pedal and hold for approximately 20 seconds until the check engine light stops blinking and stays on.
How do you reset the throttle position sensor on a Chevy Silverado?
The easiest way to reset your throttle position sensor is to unhook the negative cable from your battery for up to five minutes or to remove the fuse for your engine control module.
How do you reset the ECM on a Chevy truck?
Remove the nut off the negative battery cable with a socket set or wrench. Slide the cable off of the battery and put it aside. Turn the headlight switch to the “on” position to drain the ecm of any remaining power. Wait at least 10 minutes, then turn it back to the “off” position.
How do you recalibrate a throttle body?
Make that the accelerator pedal is completely released or free, then turn “ON” ignition switch and wait for 3 seconds. You want completely depress the accelerator pedal very hard and fully release the accelerator pedal as quickly as possible 5 times within 5 seconds.
How do I reset my throttle body after cleaning?
The idle will relearn if you put the vehicle in drive and allow the idle to come down with all accessories off for about two to three minutes. Then turn on your a/c with blower in high position for three minutes. This should fix it.
Does a throttle body have to be programmed?
In fact, on some engines a new throttle body needs to be programmed with a factory, or equivalent, scan tool. The technician cannot even clean the carbon out of the throttle body in some cases without setting a “check engine” light.
Do you have to calibrate a throttle body?
Once you have fitted a Throttle Position Sensor, or TPS, you will need to calibrate it from within MEITE. The signal on the chosen pin should sweep from approximately zero to five volts as you move the throttle from fully closed to fully open. …
Do you have to relearn after cleaning throttle body?
Cleaning the throttle body allowed more air to enter the engine, and the computer is compensating by adding more fuel. The idle will relearn if you put the vehicle in drive and allow the idle to come down with all accessories off for about two to three minutes.
When to do a Ford throttle body relearn?
If you’ve replaced your Ford electronic throttle body or you’ve disconnected the battery, you must do a Ford throttle body relearn to establish a new baseline idle. Starting in early 2000’s, many car makers including Ford started installing fly by wire electronic throttle bodies.
What happens when you replace the throttle body?
If you replace the throttle body, the PCM won’t know and will continue to use the adaptive settings as if the carbon buildup is still in place. If you don’t do a relearn procedure, the PCM will “hunt” for a new baseline idle.
How to reset the DTCs on a Chevy Silverado?
1. Remove negative battery cable for 20 minutes to reset all DTCs. 2. Start engine, run in park for 3 minutes -Engine starts at about 1200rpm, then slowly idles down to 800 rpm and back up to a steady 1000rpm 3. Remove key for 60 seconds
How is the gas pedal connected to the throttle body?
In those vehicles, the “gas” pedal isn’t connected to the throttle body by a cable. The pedal simply provides an electronic signal, telling the throttle body how much acceleration you’re requesting. A motor and gear reduction set inside the throttle body opens and closes the throttle plate to accomplish your request.